
Tack is the saddle, the bridle and every other piece of gear a horse wears to be ridden or handled. (It’s short for “tackle,” in case you wondered.) That’s the whole definition, and it’s why the word covers a long list of pieces with names that sound like a foreign language when you’re new at the barn.
Here’s the good news, y’all. Honestly, almost every name is a plain description once you know where the piece sits, and you’ll pick them up faster than you think. A crownpiece goes over the crown of the head. A browband crosses the brow. A cinch cinches. Head to hoof, the English word and the Western word often differ, and the next time someone says “grab the headstall,” you’ll know which end of the horse to walk toward.
The Halter and Lead: Tack for the Ground

The halter is the first piece you’ll ever touch at the barn, and it isn’t a bridle. Mix them up and you’ll have one very confused horse. It’s for leading and tying, not for riding. It has 6 parts: the crownpiece over the head, the cheekpieces down each side, the noseband around the muzzle, the throatlatch under the jaw, a connecting strap and a tie ring under the chin.
Fit is easy to check. The noseband should sit about 2 inches below the bony part of the cheek. Too high and it rubs the cheek. Too low and it can restrict breathing or slip right off. The lead rope that clips to the ring is usually at least ½ inch thick and 6 to 10 feet long, with a heavy-duty snap, and nylon ropes are stronger than cotton or manila.
One rule I’d put on a sign over the barn door: never leave a halter on a loose horse. A horse that catches a foot in it, or hangs it on a fencepost, could be badly hurt or killed. Halters come off when the horse goes back out to the paddock.
The Bridle: Headstall, Browband and Everything Else Up Top

A bridle is the riding version of head gear, and it’s the one that carries the bit. The strap assembly that goes over the head is the headstall, which English riders also call the crownpiece. From it hang the cheekpieces on each side, the browband across the forehead and the throatlatch under the jaw.
An English bridle adds a noseband called a cavesson. A regular cavesson lies about 2 inches below the protruding cheekbone, and you should be able to fit 1 to 2 fingers between the band and the horse’s nose. Its main job is to help keep the mouth closed so the horse can’t evade the bit. A Western headstall may have a browband or a shaped or split earpiece instead, and Western bridles often add a curb strap or chain under the chin.
Throatlatches are strongly recommended on every bridle for safety, so that little strap stays on.
Bits and Reins: The Pieces That Touch the Mouth

The bit is the part that rests in the mouth. Even the pieces of a bit have names, yes, really. The mouthpiece is what goes in the horse’s mouth, the port is the raised center of it, and the bars of the mouthpiece rest on the bars of the horse’s mouth. Above the mouthpiece is the purchase, and below it is the shank. The shank is what gives a bit its extra pull, and the shorter the shank, the less pull.
Bits come in two big families. A snaffle is any bit with a direct pull on the mouth and no extra pull, whether it’s jointed or solid. A curb bit works like a lever, with the lower jaw clamped between the mouthpiece and the curb strap, and the longer the shanks, the stronger that pull gets. Snaffles are the usual choice for starting young horses and for retraining older ones.
The curb strap or chain sits under the chin and shouldn’t be snug when the shanks hang in their normal position. You should be able to slip 2 fingers under it without applying pressure.
How the bit gets used matters more than which one it is. The bars of the mouth are bone covered with thin skin, and repeated rough treatment can leave a horse hardmouthed. A jointed bit should leave 2 or 3 creases at the corners of the mouth, and an unjointed one should leave 1 or 2.
Reins run from the bit to your hands. English reins can be laced or braided for grip, and a pelham or a full double bridle takes two sets. Western riders use split reins, two separate straps, or a romal, which has a quirt on the end. If you’re curious why the split kind has its fans, we put together a piece on why Western riders use split reins.
Here’s my usual caution at the barn. If a horse is fussing at the bit, rule out the mouth before you rule out the horse. A check with the equine dentist and your vet comes before swapping to a harsher bit, never after.
The Western Saddle, From Horn to Skirts

Inside every saddle is a tree, the frame that gives it its shape. On a Western saddle the tree’s width at the fork and the angle of its bars decide the fit. The front of the saddle is the fork, with the horn on top and the gullet, the channel that clears the horse’s withers, underneath. The seat sits in the middle, and the cantle is the back rise.
Then come the leather pieces. Skirts lie under the saddle against the horse’s back, one pair at the front and one at the rear. Fenders hang down each side over the stirrup leathers, and the stirrup is the foot piece at the bottom. Saddle strings dangle off the corners, and the latigo is the strap that ties the cinch to the saddle.
Length is measured from the base of the horn to the front of the cantle. An average stock saddle runs 15 inches, with youth sizes at 13 to 14½ inches. And when a rider is up, there should be about 2 inches of clearance between the withers and the top of the gullet.
The word rigging also shows up around Western saddles. It’s where the cinch attaches, and it can sit anywhere from right under the horn (full) to halfway to the cantle (center-fire). A horse with a well-laid-back shoulder is comfortable in a full or ⅞ rigging, and the average pleasure horse takes a ⅞.
The English Saddle: Pommel and Knee Rolls

English saddles drop the horn and most of the leather. The front rise is the pommel, the rear rise is the cantle, and between them is the seat over a gullet that clears the withers. The skirt and flap cover the stirrup leathers, the knee roll pads the front of the flap for your knee, and the billets are the straps that hold the girth.
One quirk that trips up almost every beginner is that a hunt seat saddle is often sold without its fittings. Those are the stirrup irons (English riders say “irons,” Western riders say “stirrups”), the stirrup leathers and the girth. Hunt seat saddles average about 17 inches, measured from the rivet on the side of the pommel to the center back of the cantle.
There are 3 kinds of hunt seat saddle: a jumping saddle, an all-purpose saddle, and a close contact saddle. An all-purpose is the most versatile on the flat, so it’s the one I’d look at first as a beginner. If you’re deciding what to put on your feet for those stirrups, our riding boots for beginners guide covers the heel and the sole.
Pads and Girths: What Goes Under and Around

A saddle pad or blanket protects the horse’s back and soaks up sweat, and it keeps your saddle clean too. A Western saddle needs one, while an English saddle can go without. The material changes how the pad behaves: wool makes a good blanket, hair pads wear long and absorb a great deal of moisture, felt is inexpensive but slow to dry, foam is easy to clean but doesn’t breathe or absorb sweat, and neoprene is light and easy to clean.
The strap that goes around the horse’s belly has two names. English riders call it a girth. Western riders call it a cinch. They do the same job, and the girth may be leather or synthetic. Western cinches are made of mohair, rayon, cotton or neoprene, and a wider, softer one is better. A short cinch can cause cinch sores.
Many Western saddles also have a back cinch, called a flank cinch. When there is one, it has to be joined to the front cinch with a connecting strap. A back cinch is optional for pleasure riding.
Breast Collars, Martingales and the Add-Ons

Some tack isn’t on every horse, but you’ll hear about it anyway (usually from the person at the next stall). A breast collar is a strap around the chest that helps hold the saddle in place on horses with straight shoulders, low withers and long backs. English riders have a cousin called a breastplate, which has a Y at the center of the chest and straps that run up over the shoulders to the saddle.
Martingales confuse people because there are 3 common kinds. A standing martingale runs from the noseband between the front legs to the girth. A running martingale splits into two short straps with rings that the reins pass through. A German martingale has longer straps that run through the rings of the snaffle and clip back to the reins. They’re all aimed at head carriage, and martingales should only be used with snaffle bits.
If head tossing is the only reason you’re reaching for one, ask your vet to look for a cause first.
Boots and Wraps for the Legs

Leg protection has its own vocabulary, and 4 kinds of boot do most of the talking. Splint boots, also called brushing boots, protect the cannon bone and fetlock area when a hoof brushes the opposite leg on a tight turn. Bell boots, or overreach boots, sit on the front feet and cover the heel and the coronet, which matters for a horse that overreaches with the hind toe. Skid boots shield the back of the rear fetlocks during sliding stops, and ankle or fetlock boots are shorter versions of splint boots, usually used behind.
Polo wraps are thick, stretchy bandages wrapped many times around the leg. They are the easy one to get wrong. A wrap that’s uneven or loose can come undone, trip the horse and possibly bow a tendon. If nobody has shown you how, ask your vet or a trainer to wrap one with you watching before you try it alone.
Caring for Tack and Where to Keep It

Honestly, the names matter less than knowing the stuff is safe to ride in, and you can check that yourself. Look over every piece often, especially at the buckles, the Chicago screws, the folds, the holes and anywhere the latigo attaches to the D-ring. Stitching that is rotten or pulling apart means that piece stays on the ground.
Cleaning is simple. Sponge leather after every ride to get off dirt and sweat, using plain water or a mild leather soap, and don’t dry it near heat, no matter how wet it got. Condition it lightly now and then, because too much oil collects dust and rots stitching.
Storage is where a lot of good tack gets ruined, and you’d never guess it from looking at a tidy rack. Saddles belong on racks, sawhorses or barrels, not hung from a rope or stood on their front edges. Bridles hang on wide, rounded hooks, since a thin hook like a nail can strain the leather until it cracks. And let blankets and pads hang where air can reach them. If you’re sorting out blankets this season, here’s how to measure a horse for a blanket.
When the Tack Is Fine and the Horse Still Isn’t
Tack questions have a way of turning into health questions, so here’s where I’d stop and call someone. If a saddle leaves dry spots after a sweaty ride, usually around the withers, that can be a sign of too much pressure. One that is sore to the touch or raised needs a different saddle, and that’s a call for your vet or a saddle fitter, not a fix you find in a pad.
A poorly fitted saddle can also produce a cinchbound horse, one that tries to lie down or bite, or habits like bucking. Plenty of “my horse is acting up” problems are a mouth or a saddle problem wearing a behavior costume, so check the teeth and the fit before you blame the horse. Our guide to why horses chomp at the bit goes through the common reasons.
Saddle up when it all fits. Happy trails.
A Must-Read:

How to Mount a Horse If You're Overweight?

Going Saddle-Free: How to Mount a Horse Without a Saddle?

How to Turn a Horse Western Style: A Beginner's Guide

Galloping Western Style: A Beginner's Guide

Riding Boots for Beginners: The Heel, the Sole and the Fit That Keep You Safe

Riding Heavy: The Best Horse Breeds for Carrying 400 Pounds
